|
Installation Instructions |
|
 | Aqua Shield™ Enclosure arrives fully
assembled and consists of a set of tracks, complete frame sections,
and a set of end panels, one with door and all necessary hardware. |  |
|
 | Step 1. (Figure 1): Track Installation:
A flat, level surface is recommended, preferably a 3.5" thick foundation
of reinforced concrete. Mount the tracks parallel and at opposite
sides of your pool or patio on the flat, level surface. (See enlarged Fig #1)
|
|
 |
Step 2. (Figure 2): Frame Section Installation:
Install each individual frame section by dropping it onto the tracks,
starting with the smallest. Make sure that each section is placed
in its corresponding rail. Align the anchored plate onto the frame
section and attach to hold the frame section onto the track. (See
enlarged Fig. #2)
|
|
 |
Step 3. (Figure 3): End Panel Installation:
Take the end panel and position it into the frame section. Center
it so the pin holes of the frame section line up the the pin holes
of the end panel. Then snap all the holes shut with the quick release
pins to completely fasten the end panel to the section. Repeat this
step for the end panel at the opposite end. (See enlarged Fig. #3)
| |  |
1) Find two parallel lines around the area you wish to enclose.
(See enlarged Fig. #1)
2) Place the section panels so the screw hole
in the legs lines up evenly with the parallel lines.
3) Mark holes, four per
section and remove enclosure.
|  |
4) Drill and install anchors (See enlarged Fig. #2)
5) Install the enclosure one section
at a time and fasten to the ground. 6) Place the end panel over
the section panel. Line up the holes and insert quick release pins. |
|
|
